Finish Planing / Profiling Cutterhead
 
 


Planing/Dovetailed Profiling Cutterheads

FEATURES

  • Planing knives and dovetailed profiling knives are combined in one cutterhead.
  • The cutterhead body is manufactured from aluminum alloy, anodized, dyed and dynamically balanced for extra smooth running.
  • Quick lock system planing knives.
  • Higher chip removal rate.
 
PART NO. CUTTING
CIRCLE		 CUTTING
LENGTH		 BORE
DIAMETER		 PLANING
KNIVES		 DOVETAIL
SLOTS		 BORE SIZE **
PAC125100**402 125 100 ** 4 2   1-1/4" 32
PAC125150**402 125 150 ** 4 2   35 mm 35
PAC125200**402 125 200 ** 4 2   1-1/2" 38
PAC125230**402 125 230 ** 4 2   40 mm 40
PAC125240**402 125 240 ** 4 2   46
PAC140100**402 140 100 ** 4 2   50 mm 50
PAC140150**402 140 150 ** 4 2   2 1/8" 54
PAC140230**402 140 230 ** 4 2   60 mm 60
              65 mm 65
 


Planing/Multi - Profiling Cutterheads

FEATURES

  • A universal cutterhead that combines planing knives, dovetailed profiling knives and solid profiling knives in one cutterhead.
  • The cutterhead body is manufactured from aluminum alloy, anodized, dyed and dynamically balanced for extra smooth running.
  • Quick lock system planing knives.
  • Higher chip removal rate.
 
PART NO. CUTTING
CIRCLE		 CUTTING
LENGTH		 BORE
DIAMETER		 PLANING
KNIVES		 PROFILING
KNIFE SLOTS		 DOVETAIL
SLOTS		 BORE SIZE **
PAD125100**222 125 100 ** 4 2 2   1-1/4" 32
PAD125150**222 125 150 ** 4 2 2   35 mm 35
PAD125200**222 125 200 ** 4 2 2   1-1/2" 38
PAD125230**222 125 230 ** 4 2 2   40 mm 40
PAD125240**222 125 240 ** 4 2 2   46
PAD140100**222 140 100 ** 4 2 2   50 mm 50
PAD140150**222 140 150 ** 4 2 2   2 1/8 54
PAD140230**222 140 230 ** 4 2 2   60 mm 60
              65 mm 65
 



FEATURES

  • Suitable for PAA, PAB and PAD series cutterheads.
  • H.S.S. knife material.
  • Quick lock system knife.
  • Knife can be surface ground to a minimum of 2.45 mm thickness.
  • Knives are 14 mm wide x 2.55 mm think.
 Quick Lock Knife Specification


 

Quick Lock System Instruction

STEP 1
Loosen set screws by using a 3mm hexagonal wrench.
 
STEP 2
Use the hexagonal wrench to gently tap down the gib, then you can take out the knives radially.
 
STEP 3
To mount new knives or use the other edge of the knife, make sure the knife is properly engaged with the cavity on the cutterhead body.
 
STEP 4
Tap down again the gib, then the gib will automatically precisely secure the knife in place. Finally, tighten all set screws.