Finish Planing / Profiling Cutterhead
 
 


Planing/Finishing Cutterheads

FEATURES

  • Quick lock system.
  • Centrifugal knives clamping during running for dependable clamping at all times.
  • Knives change from radical direction for added convenience without restriction by limited space at both ends of cutterhead.
  • Reversinle HSS-knives induded.
  • Aluminum alloy cutterhead body, anodized, dyed and dynamically balanced for extra smooth running.
  • Choice of 2 to 6 knives cutterhead configuration.
  • High cutting circle accuracy in 0.03 mm.
 
PART NO. CUTTING
CIRCLE		 CUTTING
LENGTH		 BORE
DIAMETER		 KNIVES BORE SIZE **
PAA125100**400 125 100 ** 4   1-1/4" 32
PAA125150**400 125 150 ** 4   35 mm 35
PAA125200**400 125 200 ** 4   1-1/2" 38
PAA125230**400 125 300 ** 4   40 mm 40
PAA125240**400 125 240 ** 4   1-13/16" 46
PAA140100**400 140 100 ** 4   50 mm 50
PAA140150**400 140 150 ** 4   2 1/8" 54
PAA140230**400 140 230 ** 4   60 mm 60
            65 mm 65
 


Planing/Solid Profiling Cutterheads

FEATURES

  • Combine planing knives and solid profiling knives in one cutterhead.
  • The cutterhead body is manufactured from aluminum alloy, anodized, dyed and dynamically balanced for extra smooth running.
  • Quick lock system planing knives.
 
PART NO. CUTTING
CIRCLE		 CUTTING
LENGTH		 BORE
DIAMETER		 PLANING
KNIVES		 PROFILING
KNIFE SLOTS		 BORE SIZE **
PAA125100**420 125 100 ** 4 2   1-1/4" 32
PAA125150**420 125 150 ** 4 2   35 mm 35
PAA125200**420 125 200 ** 4 2   1-1/2" 38
PAA125230**420 125 300 ** 4 2   40 mm 40
PAA125240**420 125 240 ** 4 2   46
PAA140100**420 140 100 ** 4 2   50 mm 50
PAA140150**420 140 150 ** 4 2   2 1/8" 54
PAA140230**420 140 230 ** 4 2   60 mm 60
              65 mm 65
 



FEATURES

  • Suitable for PAA, PAB and PAD series cutterheads.
  • H.S.S. knife material.
  • Quick lock system knife.
  • Knife can be surface ground to a minimum of 2.45 mm thickness.
  • Knives are 14 mm wide x 2.55 mm think.
 Quick Lock Knife Specification


 

Quick Lock System Instruction

STEP 1
Loosen set screws by using a 3mm hexagonal wrench.
 
STEP 2
Use the hexagonal wrench to gently tap down the gib, then you can take out the knives radially.
 
STEP 3
To mount new knives or use the other edge of the knife, make sure the knife is properly engaged with the cavity on the cutterhead body.
 
STEP 4
Tap down again the gib, then the gib will automatically precisely secure the knife in place. Finally, tighten all set screws.